Pallet turners

Structure:  12mm thick sheet metal flame-cutting structure.

Drive:  drive by motor-reducer-brake with torque limiter, sprockets and chain.

Fixing:  fixing of the load during dumping by a system of four retractable hydraulic lashings and a system of 1 to 3 scissor tables actuated by an electro-hydraulic group with cylinders, electric motor (IP-55), pump, tank, solenoid valves, piloted non-returns , etc.

Stops: front and rear defense stops to prevent the turner from hitting the load during its introduction.

Electrical control: electrical control according to EN 60204-1 in a cabinet with a main switch that can be locked with a padlock. Start and stop buttons. Magnetothermic circuit breaker, etc. With retained signal type operating pushbuttons and emergency stop pushbutton. With support for fixing on the ground.

Operating modes: electric maneuver with 2 operating modes by key selector; manual and automatic.

Others: hole to facilitate the access of the nails of the LGVs.

At Eyher we specify, design and manufacture turners for changing pallets in industrial processes where the load is required to be turned over to change an origin pallet (pallet with which the load is transported, for example) to a destination pallet (pallet with which a process is going to be carried out with the charge, such as a heat treatment or a press charge for example) .